Deploying the Smart Citizen KitLink
The Smart Citizen Kit can be used in both, indoor or outdoor setups. This page gives guidelines on how to install in either situation.
In indoor conditions, the Kit can be installed using this 3D printed clip.
How to install the kitLink
Make sure you read the information about each type of sensor before installation:
- Keep the sensors powered if they are going to be mounted in a fixed point
- Avoid areas with moist accumulation when possible
- Avoid temperature and humidity transients, specially for the eCO2/tVOC sensor
- Avoid covering the sensors, specially the PM sensor
- Avoid covering the microphone and particles to go in the microphone port
- Avoid direct flow towards the sensors. If exposed under flow conditions, have the flow go parallel to the sensors' surface
For outdoor installation, an enclosure is recommended in order to avoid moisture to damage the sensors and electronics. The Enclosures Repository contains various types (3D printed, milled, DIY) from us and contributions from users that customise their own! Feel free to download the models and tweak them, and if happy, share them back via pull request to the repository.
The general tips from above also apply, as well as:
- Avoid exhausts from air conditioning units, kitchens and others
- Protect the sensors from moisture either using filtering foam or nail polish to cover the sensor pads (see here)
- Avoid temperature transients, specially due to sun radiation
Powering the sensorLink
The SCK can be powered through:
- LiPo 3.7V Battery: default 2000mAh - large 6000mAh
- Mains power, through an USB adaptor (not recommended) or a custom power supply in this enclosure
- Solar panel: we use the Solar Panel 6W 6V from Voltaic Systems with the MPTT DF Robot DFR0559 and an additional LiPo Battery, all in this enclosure
Using the custom power supplyLink
The power supply is very simple to operate. If you have purchased one, normally, everything should be connected and ready to go. In some cases, the AC cable (left screw connector) is not connected, and it can be simply connected through the cable gland into the terminals. No ground is required.
When connecting the plug to the wall socket, the red LED should turn on indicating 5V output. The input is protected with a 1A Fuse and the pack should be enclosed in a waterproof enclosure as detailed here.
The sensors can log data in sd card or remote post data to the Smart Citizen Platform. In the case of remote logging and outdoor deployments, a connectivity unit can be used with a SIM Card data plan. These units are enclosed in a waterproof box and can be powered from 230VAC 3m cable (or more), deploying a network to which several SCKs can be connected in an outdoor deployment.
Check this installation guide to get started