# Updating the Wi-Fi credentials This guide will help you update your kit's Wi-Fi settings. !!! warning :white_check_mark: The kit supports Wi-Fi WEP, WPA/WPA2 and open networks that are common networks in domestic environments and small businesses. :negative_squared_cross_mark: But, it **does not** support WPA/WPA2 Enterprise networks such as EDUROAM or networks with captive portals such as those found in Airports and Hotels ## Connect to the Kit - Click your **kit button** until the kit is in [setup mode](https://docs.smartcitizen.me/hardware/kit/features.md#setup-mode), the LED should be red.  - **Connect to the kit** with your mobile device as you did during the installation process. You will need to search for a **Wi-Fi network** called `SmartCitizen[···]`. If you have multiple kits `[···]` is the unique identifier of your kit. - Once connected **you should see the Setup App in your phone**. If it doesn't show up automatically you can open http://192.168.1.1 on your phone browser. !!! info The process also works on laptops, desktops and tablets, connected than can connect to the `SmartCitizen[···]` network. ## Update the Wi-Fi - On the app **choose start** to move to the next page.  - You will see your **device key** or **token**. Do not change it and **choose next**.  - Set your new Wi-Fi settings on the next screen as you did during the installation process.  - The LED will go blue and **your kit should start to publish again using the new Wi-Fi**. You can confirm it by visiting your device on [smartcitizen.me/kits](https://smartcitizen.me/kits). You can repeat the process as many times as you want by going back to step 1. !!! info If your Kit is not publishing check the [LED status chart](https://docs.smartcitizen.me/hardware/kit/features.md#operation-modes) to know more about it.