Deployment iSCAPE Station V2

Components

Sensors

The sensors of the iSCAPE Living Lab Station V2.0 are the same as the ones in the iSCAPE Station V1.0.

The Pack

• Smart Citizen Station

  • Urban Board 2.1
  • Data Board 2.1
  • PM Board 2.0 + 2 PM sensors
  • Gas Pro Board 2.0 with 3 EC sensors
  • 6Ah Battery

• Accessories

  • MicroSD card 512MB
  • USB Charger
  • MicroSD to SD card adapter
  • Smart Citizen Power Supply (Traco P.S. 230AC in - DC5V out)
  • 2m 3-Wire 220V cable
  • Mounting brackets
  • Mounting tools (1 x Allen Key)
  • Enclosure
  • Mounting bracket
  • Thermoconformed Umbrella

Instructions

To start the installation simply visit the setup website stations.iscape.smartcitizen.me.

Warning

We keep track internally of all sensor deployments and it is very important not to swap the internal components between Station to avoid mismatchs on the calibration data.

Outdoor installation

WIP

This section is WIP

Power

The iSCAPE Station has a battery life of 12 hours as is intended as a backup solution only. That's why a power supply needs to be installed as decribed below. When we no longer want to publish or save more data for a few days we can turn off the kit. To do this, press the button for 5 seconds.

If the colors of the LED appear orange indicates that the battery must be charged.

The battery takes about 4 hours to fully charge. When the battery is fully charged, change the orange to green .

Remember that in addition to the colors you will have the state color of the kit: configuration, network and sd.

Power supply

The Station can be directly powered at 220V AC (max consumption 5W).

Working on batteries

The Smart Citizen Station has a higher consumption than the kit, mostly due to the fans on the two PM sensors. That means the internal battery last just for 20h, and it is only aimed at providing backup power.